We are SPL-Lab USA Distribution
Authorized Distributor and Tech Advisor for Taramp's - SPL-Lab USA
Number of Channels - 1
@ 14.4 VDC - 2 OHMS: 10000W RMS
@ 14.4 VDC - 4 OHMS: 6700W RMS
@ 14.4 VDC - 8 OHMS: 3886W RMS
Input Sensitivity: 250mV @ (-9,78 dBm)
Total Harmonic Distortion (THD): 0.3%
Signal / Noise Ratio: >95dB
Frequency Response: 5Hz to 15kHz
H. P. F (High Pass Filter): 5Hz to 50Hz(-12db) Variable
L. P. F (Low Pass Filter): 50Hz to 15kHz(-12db) Variable
Input Impedance: 18k OHMS
Protection: Short on the Output / Supply Voltage High/Low / Low Impedance / Thermal Protection
Minimum Supply Voltage: 9.0VDC
Supply Voltage: 16VDC Maximum
Consumption at Rest: 3.6 Amp.
Maximum Consumption Musical @ 12.6VDC: 539.5 Amp.
Maximum Consumption in Sinusoidal Signal (1kHz) @ 12.6VDC: 1079 Amp.
Dimensions (WxHxD): 9.06" X 2.87" X 19.57"
Recommendations of Operational Use-
SPL-Lab USA strongly advises to follow these guidelines to have error-free operation.
Do not mount amplifier to speaker box. Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
Do not wire this amplifier lower than 2ohm nominal Impedance. (Equivalent to ~1.4 ohms DCR or Resistive measurement via DMM).
Do not clip amplifier above 14.9v for extended periods of time
Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)