Full Digital Controlled settings
H. P. F (High Pass Filter): 20Hz to 1KHz (-24db) Variable (or Full Pass)
L. P. F (Low Pass Filter): 50Hz to Full Range (-12db) Variable
Bass Boost: 0 - 10.5 dB Centered at 50Hz
Input Impedance: 18k OHMS
Protection: Short on the Output / Supply Voltage High/Low
Minimum Supply Voltage: 9.0VDC
Supply Voltage: 16VDC Maximum
Consumption at Rest: 1.50 Amp.
Maximum Consumption Musical @ 12.6VDC: 163 Amps
Maximum Consumption in Sinusoidal Signal (1kHz) @ 12.6VDC: 325 Amps.
Dimensions (WxHxD): 9.02" X 2.56" X 8.94"
Weight: 5.4 lbs
This amplifier has an onboard advanced configuration for even MORE features-
ANTI-Clipping Module- Variable from 1%-30%, this setting has the ability to resist speakers from being clipped or clipped for long enough to cause thermal damage.
Phase Control- 2 options to choose- 0 or 180.
Bass Boost Center Frequency Control- Change the centered frequency of boost from the following options- 40Hz, 50Hz (default), 60Hz or 80Hz
Recommendations of Operational Use-
SPL-Lab USA strongly advises to follow these guidelines to have error-free operation.
Do not mount amplifier to speaker box. Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
Do not wire this amplifier lower than 1ohm nominal Impedance. (Equivalent to ~0.7 ohms DCR or Resistive measurement via DMM).
Do not clip amplifier above 14.5v for extended periods of time
Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)